hey gents, as you may see im new to the site but i have been viewing for a few weeks now.

before anyone jups down my throat i have looked around the site but im still non the wiser

i currently building 2 lupo's with 1.8t engines from audi s3's, both of which use me7.5 ecus.

im looking to do immo defeat on both ecus, but im not very computer literate when it comes to cmd

can someone kindly explain exactly how id go about this? i think i know how to get it into bootmode but once im in bootmode what do i need to do?

ideally a step by step guide for dummies 

i did buy a vagdash software thingy which is ment to disable the immob but cant even get the thing to open the software 

any help appreicated 

Here is a vid I made to show how to read and write the EEPROM. This is your first step to immo off. The gui is floating around too to make it easier

Great video, except someone has to do a lot of research, for example which pin or wire is +12V? Which one is ground? Which one to connect to your OBD2 connector? If this is done in a lab like the video shows, a person would need more info. From the picture you can see some ping is being grounded, but it is not very clear which one (24?). Someone without much experience can easily fry something.

Mocke is right. That topic is well covered. The video was intended to show the immo part, not flashing in general.

For future reference here is the thread which covers pin outs/benching/flashing: http://nefariousmotorsports.com/forum/index.php?topic=417.0title=