Pages: [1]
Author Topic: Load vs TMOT - ME 7.5  (Read 6842 times)
20VTMK1
Full Member
***

Karma: +0/-0
Offline Offline

Posts: 113


« on: August 03, 2015, 01:09:29 PM »

Hi all ,

Hope everyone is well

I noticed an issue as of late , when I go WOT after a long light throttle cruise , the boost wont go past 1.1 bar . After a few pulls and an increase in coolant temp , or so I assume - as the oil temp goes up , the boost will then go to the normal mark of 1.5 bar . Now I understand that the boost is a function of load , which depends on quite a few factors but a delta of 0.4 bar is quite a bit .

Driving in the warmer afternoons does not yield the above result , its full specified boost all the way .

Perhaps there is an issue with the coolant senor - I will change that - just need a pointer to see if there is TMOT limiter for Load in higher gears

This is for BAM engine , Me 7.5

Thank you in advance
Logged
fknbrkn
Hero Member
*****

Karma: +186/-24
Offline Offline

Posts: 1456


mk4 1.8T AUM


« Reply #1 on: August 04, 2015, 01:56:39 AM »

KFFKRXTM
but it limits load only at high engine temps.. ~110C+
« Last Edit: August 04, 2015, 02:00:12 AM by fukenbroken » Logged
contrast
Full Member
***

Karma: +20/-3
Offline Offline

Posts: 215


« Reply #2 on: August 04, 2015, 03:30:26 AM »

I posted a similar topic a while ago: http://nefariousmotorsports.com/forum/index.php?topic=8537.0title=

But no definite answer yet
Logged
20VTMK1
Full Member
***

Karma: +0/-0
Offline Offline

Posts: 113


« Reply #3 on: August 04, 2015, 12:24:03 PM »

Hi ,

I don't think TANSMN is the awnser  - is that not intake air temp ?

I am convinced my problem lies with the coolant temp maps . I have a colder thermostat valve from the TT sport , BFV variant .

Any ideas chaps ? If you point me in the correct direction , I can read it up ?

Thanks
Logged
nyet
Administrator
Hero Member
*****

Karma: +608/-168
Online Online

Posts: 12271


WWW
« Reply #4 on: August 04, 2015, 03:13:43 PM »

Log please.
Logged

ME7.1 tuning guide
ECUx Plot
ME7Sum checksum
Trim heatmap tool

Please do not ask me for tunes. I'm here to help people make their own.

Do not PM me technical questions! Please, ask all questions on the forums! Doing so will ensure the next person with the same issue gets the opportunity to learn from your ex
20VTMK1
Full Member
***

Karma: +0/-0
Offline Offline

Posts: 113


« Reply #5 on: October 03, 2015, 12:53:52 PM »

Hi guys

It was indeed the coolant sensor . Replaced this and all seems good now .

Will get some logs in any case and send

Thanks
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.015 seconds with 17 queries. (Pretty URLs adds 0s, 0q)