Pages: [1]
Author Topic: replacing 29f400 chip  (Read 4559 times)
littco
Hero Member
*****

Karma: +52/-7
Offline Offline

Posts: 903


« on: August 08, 2011, 07:32:55 AM »

Quick question. I had got a new chip for my edc15 ecu, as it can't be bootmoded to recover. Do I need to flash the chip prior to installing or can I install and then flash once on board the ecu. Just wondered if a fresh new chip can be written to over obd or whether it needs flashing with a willem program 1st. Cheers
Logged
robin
Full Member
***

Karma: +20/-1
Offline Offline

Posts: 139


« Reply #1 on: August 08, 2011, 07:44:39 AM »

You can program a blank chip in boot mode, but for it to be OBD flashed it needs to have a checksummed .bin on it first.
Logged
littco
Hero Member
*****

Karma: +52/-7
Offline Offline

Posts: 903


« Reply #2 on: August 08, 2011, 08:16:32 AM »

Brilliant, thank you. Also are there any issues putting a 29f800 chip in the place of a 29F400 chip?
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.011 seconds with 15 queries. (Pretty URLs adds 0s, 0q)