Hey everyone,

I'm having some trouble trying to write to a 24c02 out of a 2001 2.0l Beetle ME5.9 ECU (06A 906 018 EQ).

I'm able to read the chip perfectly fine, but when I go to write to it, I am unable to write them.

After some testing I found that I can write to "half" of the chip, see below:

Original:


Half Written:


I have tried grounding the WP (pin 7) to make sure that the Write Protect is disabled but I get the same results.

Any ideas what's going on / what I'm doing wrong? I'm using WLPRO with an SP200SE Chip Programmer to flash the chip.

Thanks in advance!

Thanks, I don't think it's a bad contact as I have it soldered to an adapter for my chip programmer.

I was wondering if some of them might not be able to be programmed.

Thanks for the tips!

Pull it off the board, write it speed 0, or slow.