Pages: 1 [2]
Author Topic: EURO S4 Kline interompt cluster bypass ?  (Read 24375 times)
A6turbofrance
Full Member
***

Karma: +0/-5
Offline Offline

Posts: 117


« Reply #15 on: January 24, 2016, 04:25:28 AM »

i have done i will test it when the new ecu will arrive
Logged
tightmopedman9
Jr. Member
**

Karma: +0/-2
Offline Offline

Posts: 45


« Reply #16 on: October 31, 2022, 03:57:29 PM »

I had the same issue as the OP on a 2002 Audi C5 Allroad, manual transmission for what its worth. I fixed my issue by snipping the K-line right before it entered the cluster. I then spliced a wire to both cut ends and ran that to a SPST switch, which I placed next to the OBDII port. When I want to log, I turn the switch to the OFF position, leaving the cluster out of the k-line bus. When I want to read codes etc, I turn the switch to the ON position.

For my car, the K-line wire going into the cluster was at T32a/28, a green wire with red stripe. The T32a connector is the green one.
Logged
Pages: 1 [2]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.012 seconds with 16 queries. (Pretty URLs adds 0s, 0q)