James100275
Newbie
Karma: +0/-0
Offline
Posts: 2
|
|
« on: January 31, 2016, 12:32:55 PM »
|
|
|
Hi,
I'm trying to virginise an Alfa 147 2.0 manual ECU (0 261 206 708) ME731HA002.
I've got it set up on a bench and read the EEPROM using the following: ME7EEPROM.exe --bootmode 95080 -r -p3 --CSpin P4.7 orig.bin
C:\alfa>ME7EEPROM.exe --bootmode 95080 -r -p3 --CSpin P4.7 orig.bin ME7_EEPROM v1.40 COM: 3, Baud Rate: 10400 Memory type: 95080, size: 1024 Chip Select pin: P4.7 Opening COM3 ... OK Starting Boot_mode ... uC ID response 0xC5: C167CR ... OK Sending Loader + MonitorCore ... MonitorCore successfully launched Initializing registers ... OK Sending EEPROM driver ... OK Configuring SPI Interface ... OK Checking EEPROM Status Register ... 0x0080 Reading EEPROM ... OK File saved Closing COM3
I've altered the orig file to virginise it: 50 & 60 orig: FF FF C0 48 45 D9 7B 25 25 FF 7F 84 57 50 5F 06 FF FF C0 48 45 D9 7B 25 25 FF 7F 84 57 50 5F 06 to: FF FF C0 48 45 D9 7B 25 DA FF 7F 84 57 50 AA 05 FF FF C0 48 45 D9 7B 25 DA FF 7F 84 57 50 AA 05
I then write the file using the following: C:\alfa>ME7EEPROM.exe --bootmode 95080 -w -p3 --CSpin P4.7 virgin.bin ME7_EEPROM v1.40 COM: 3, Baud Rate: 10400 Memory type: 95080, size: 1024 Chip Select pin: P4.7 Opening COM3 ... OK Starting Boot_mode ... uC ID response 0xC5: C167CR ... OK Sending Loader + MonitorCore ... MonitorCore successfully launched Initializing registers ... OK Sending EEPROM driver ... OK Configuring SPI Interface ... OK Checking EEPROM Status Register ... 0x0080 Writing EEPROM ..OK Closing COM3
After writing, I power down/up the ECU and read the file as in the first step. The problem is that the file I now read is identical to the orig - it hasn't changed.
Any help would be greatly appreciated. James Files attached
|
|
|
Logged
|
|