"failed to read test echo from FTDI device" error

[NestorS4B5]

im having same issue with Ross-tech hex+can cable i loaded the rosstech drivers still no good

[EuroXs4]

I was having the same issue with a cable.However it works without issues with the galletto clone reading and writing without issues.So thats what Ive been using.Cheap/free software!!LOL

[EuroXs4]

So I ordered this recommended cable by you guys from the thread.I still get the same error Failed to read test echo from FTDI device.I am running windows7.anyone know what gives??Cable is being recognized as a FT232R UART.According to windows its a usb to serial converter??Do I have to install other drivers perhaps??


this is the cable I recieved.

http://www.ebay.com/itm/USB-cable-for-Triumph-Motorcycles-TuneECU-FTDI-FT232RL-Chip-OBD-II-KTM-Tune-ECU-/301748110752?hash=item464196c5a0:g:B5oAAOSwFnFWAa8h&item=301748110752&vxp=mtr

[macxxx]

I run Windows 7 and I use drivers from ftdi page , had no issues with them.