Pages: 1 ... 10 11 [12]
Author Topic: Tuning instrument cluster gauges for Audi/VW/Seat/Skoda  (Read 64617 times)
stuydub
Full Member
***

Karma: +17/-7
Offline Offline

Posts: 162


« Reply #165 on: March 16, 2021, 02:10:00 AM »


All u need is here :

https://mega.nz/file/iq5XBSZT#rx7sXb5z8ML7iTm61n_WYSZLcgDXOOIQSkB6VC8M2Q8
Logged
vt86
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 5


« Reply #166 on: March 17, 2021, 02:08:06 AM »

Found solution for my problem. I'm feeling bit stupid right now. Some reason Vag-k+can was skip neg.response mode. With out that it read only few lines. After cluster reset everything worked fine. So if someone else will do same noob mistake. Reset your cluster and try again.  Grin


edit:
Also for info genuine RossTech VCDS cable can be used with VAG eeprom 1.19g (set to dumb mode). But because problematic old laptop I ended using another laptop with vag-k+can 3.6
« Last Edit: March 17, 2021, 06:44:06 AM by vt86 » Logged
MiroCro
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 4


« Reply #167 on: March 31, 2021, 04:32:04 PM »

Hello,dash in my '98 octavia 1.6sr(1u1919034j) reads about 20 km/h lower than before(about 10km/h lower than gps) after upgrading from rod-operated to cable-operated gearbox out of the '03 1.8t.
also,if it's possible i would like to adjust speedometer scale so i can fit background foil out of the 240km/h octavia dash 1u0920811b.
can someone give me some guidelines how to do this,as i have no experience at this field?i have vag eeprom programer v1.19g and vag k+can commander full v2.5
both dumps are in attachment,i can also attach dumps from two mk4 golf clusters(1j0919660x-220km/h out of 1.4 16v and 1j0920820a out of vr5)  if it'll be easier to transfer speedomeret scales in my cluster's eeprom.
thanks in advance!
« Last Edit: March 31, 2021, 04:35:17 PM by MiroCro » Logged
MiroCro
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 4


« Reply #168 on: April 13, 2021, 03:29:35 AM »

Anyone? Undecided
Logged
stuydub
Full Member
***

Karma: +17/-7
Offline Offline

Posts: 162


« Reply #169 on: April 15, 2021, 05:41:25 AM »

Anyone? Undecided

Transfer a dump over from a 1.8t cluster remember to transfer IMMO DATA over if needed
Logged
MiroCro
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 4


« Reply #170 on: April 15, 2021, 12:35:14 PM »

Dumps aren't same...
Logged
stuydub
Full Member
***

Karma: +17/-7
Offline Offline

Posts: 162


« Reply #171 on: April 16, 2021, 04:54:16 AM »

Dumps aren't same...

AND ? i running Octy cluster in a mk4 with mk4 dump on it..Code the clocks in as normal the re read dump and edit
Logged
Nasenbastl
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 17


« Reply #172 on: April 16, 2021, 06:32:04 AM »

Checksumme Huh??
Logged
stuydub
Full Member
***

Karma: +17/-7
Offline Offline

Posts: 162


« Reply #173 on: April 16, 2021, 07:46:24 AM »

Checksums aint a really big issue with these clusters
Logged
Steven97i1
Full Member
***

Karma: +0/-0
Offline Offline

Posts: 68


« Reply #174 on: July 03, 2021, 03:15:07 PM »


it says eeprom not supported with my 8l0 920 931 E

eeprom attached!

Read with VAGTacho, eeprom programmer v19 not Working (unkown hardware number)
wanted something like needle swap and my kmh is not working correctly (+5KMH gps)
Logged

Searching for All XDF for an Free XDF database ONLY for nefariousmotorsports.com
Elder2000
Newbie
*

Karma: +1/-0
Offline Offline

Posts: 1


« Reply #175 on: July 21, 2021, 07:28:50 PM »

Hello
Auto after SWAP Skoda Octavia 1.8T plus DSG.
On the dashboard of the Golf R32 it shows the gear numbers.
On the dashboard  of the Octavia it does not show.


Hi
I recently swapped the exchange to dsg dq250 here in Brazil
and I have the same problem of not showing the current gear
managed to solve?
Logged
stuydub
Full Member
***

Karma: +17/-7
Offline Offline

Posts: 162


« Reply #176 on: July 22, 2021, 10:27:30 AM »

Reflash with r32 dump or change software coding
Logged
Pages: 1 ... 10 11 [12]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.021 seconds with 18 queries. (Pretty URLs adds 0.001s, 0q)