|
Title: Hardcut and launch control 4b0906018cg Post by: xcvz1215 on March 12, 2023, 02:57:39 PM Hi, if i have launch control set 4500rpm. In KFTSRL and KFSZT set last row 4500 value=0?
RPM normal limit is 7000, so i must set last row ~6600 or can i set 4500 ? Title: Re: Hardcut and launch control 4b0906018cg Post by: xcvz1215 on April 10, 2023, 11:43:47 AM On this setting hardcut set 4500 so engine max RPM 4500
So i use 2stepscript and it work fine. Normal hardcut set 6600 , launch 5000 RPM when car stop and launch 4500rpm with cluch pedal push (flames big). When car drive max RPM 6600 and when push pedal cluch max RPM 5000 with flames ;) . On 3" exaust work very fine Title: Re: Hardcut and launch control 4b0906018cg Post by: _nameless on April 17, 2023, 06:50:09 AM Hi, if i have launch control set 4500rpm. In KFTSRL and KFSZT set last row 4500 value=0? KFTSRL and KFSZT are dwell tables and setting these tables for spark cut is a hack. However, you can use it for a hard cut rev limiter, but not launch control. You need additional logic for spark cut launch control as the dwell tables are only turning off the spark at the rpm you zero it at and nothing more. Also, it works better if you set ftomn to 0 or .1RPM normal limit is 7000, so i must set last row ~6600 or can i set 4500 ? |