|
Title: Is ME9.1 compatible with each other Post by: Iceman160785 on March 19, 2015, 03:51:44 PM Hey!
Mybe a noob question :-[ But i ask anyway! :D Is all VAG ME9.1 compatible with each other? i mean is it poosible to use Golf 6 2.0TFSI software on a Audi S3 2.0TFSI ECU? ??? Hope you can take your time to answar me on this!? Thanks Guys! ;D Title: Re: Is ME9.1 compatible with each other Post by: ddillenger on March 19, 2015, 04:00:23 PM Yes. All 2.0 FSI ecus are the same, with the exception of the GolfR
Title: Re: Is ME9.1 compatible with each other Post by: Iceman160785 on March 19, 2015, 04:12:25 PM Ok thanks for fast answear! ;D So the Golf R Ecu is special? and not compitable?
Title: Re: Is ME9.1 compatible with each other Post by: prj on March 20, 2015, 06:10:41 AM MED9.5 I believe, similar to Audi RS6 and TT-RS ecu's, quite different in some ways from the earlier MED9.1 stuff.
Title: Re: Is ME9.1 compatible with each other Post by: IamwhoIam on March 20, 2015, 10:03:07 AM Golf R uses the same ECU as ANY other 2.0 TFSI with MED9.1.
TT-RS and RS6 ECUs are also not 100% the same and not compatible, and they are MED9.1.2, not MED9.5. Title: Re: Is ME9.1 compatible with each other Post by: RaraK on March 20, 2015, 10:21:16 AM Hey! Mybe a noob question :-[ But i ask anyway! :D Is all VAG ME9.1 compatible with each other? i mean is it poosible to use Golf 6 2.0TFSI software on a Audi S3 2.0TFSI ECU? ??? Hope you can take your time to answar me on this!? Thanks Guys! ;D Not necessarily, there are some differences in SOFTWARE that will not work directly, as well as hardware on the specific car, Dash, Sensors, Turbo, etc..... Title: Re: Is ME9.1 compatible with each other Post by: prj on March 20, 2015, 12:31:13 PM Golf R uses the same ECU as ANY other 2.0 TFSI with MED9.1. TT-RS and RS6 ECUs are also not 100% the same and not compatible, and they are MED9.1.2, not MED9.5. Thanks for clearing that up. Don't remember all the denominations, but TT-RS and RS6 both had a different MPC chip inside IIRC and some of the torque control was different. Some traces of MED17 were present too. Been a bit now since I had either of those on the table. Title: Re: Is ME9.1 compatible with each other Post by: IamwhoIam on March 21, 2015, 12:37:10 PM I usually have meals on my table :D
Title: Re: Is ME9.1 compatible with each other Post by: Iceman160785 on March 21, 2015, 02:54:26 PM Ok Thaks for input guys!:) When it comes to hardware/Engine Golf R TFSI and Audi S3 2.0TFSI is all the same. Reason i ask i have a good Golf R file that i want to use in my S3. but have been told i maybe brick my ecu if i flash with Golf R file. checksum calculation is not any problem . You think this will happend?
Title: Re: Is ME9.1 compatible with each other Post by: ddillenger on March 21, 2015, 03:46:56 PM Ok Thaks for input guys!:) When it comes to hardware/Engine Golf R TFSI and Audi S3 2.0TFSI is all the same. Reason i ask i have a good Golf R file that i want to use in my S3. but have been told i maybe brick my ecu if i flash with Golf R file. checksum calculation is not any problem . You think this will happend? You shouldn't do that. The ecu won't brick, but the software is very chassis specific. Title: Re: Is ME9.1 compatible with each other Post by: Iceman160785 on March 21, 2015, 03:57:39 PM Thanks ddillenger! :) What will most likely happen if i try?:) car will not start? or will not run good?
|