Hey Everyone,
Been a long time lurker and have been reading up on the proper procedures how to do things. I finally got the time to actually install the software and try to read / edit the files.
Everything went smooth until i had to do a full read of the ECU. I get the following error; Validation failed, ECU reports RequestUpload service is not supported. RequestUpload may have been disabled by aftermarket engine software.
The car is a 2002 A4 1.8T and its stock ( boost 8-10 psi). Ive read a few posts where guys ran into this issue when they were trying to bench flash. I am not trying to bench flash, I left the ECU in the car.
Ive tried playing with the baud rates, tried slow and fast int(fast didnt work at all). Installed different Ftdi drivers. I tried each memory layout with different baud rates. I can read ecu Info with no issues.
Current setup: Windows 7 x64, OEM Rosstech cable, VCDS 14.10 with boot intelligent mode turned off. FTDI drivers from the website and the ones that rosstech suggested. (
http://www.ross-tech.com/vag-com/usb/virtual-com-port.html )
#######READ ECU INFO LOG################
Validated FTDI device is in dumb mode.
Disconnected
Connecting...
Starting slow init connection.
Connecting to address 0x01.
Slow init succeeded.
Switching to KWP2000 session.
Connected
Disabling Windows sleep mode.
Reading all ECU info.
Starting diagnostic session.
Unable to properly start diagnostic session, attempting to continue with current undefined session.
Negotiating communication timings.
Successfully changed to new communication timings.
0% complete.
20% complete.
40% complete.
60% complete.
80% complete.
100% complete.
Read 5 ECU info entries:
0x92, System Supplier ECU Hardware Number: 0261206878
0x94, System Supplier ECU Software Number: 1037360910
0x91, Vehicle Manufacturer ECU Hardware Number: 0x0D, 8E0909018 , 0xFF
0x9B, Calibration Date: 8E0909518F , 0001, 0x0300416F, 0x00000000, 0xF777, 1.8L R4/5VT , G
0x9C, Calibration Equiment Software Number: 0x00000000
Restoring Windows sleep mode.
Disabling Windows sleep mode.
#######FULL READ FLASH LOG: #############
Starting slow init connection.
Connecting to address 0x01.
Slow init succeeded.
Switching to KWP2000 session.
Connected
Disabling Windows sleep mode.
Reading ECU flash memory.
ECU reports programming session preconditions have been met.
Negotiating communication timings.
Timing negotiation failed. Communication timings are unchanged.
Requesting security access.
Security access granted.
Starting diagnostic session.
Successfully started diagnostic session.
Negotiating communication timings.
Successfully changed to new communication timings.
Requesting security access.
Security access granted.
Validating flash memory starts at 0x00800000 and ends at 0x00900000.
Validation failed, ECU reports RequestUpload service is not supported. RequestUpload may have been disabled by aftermarket engine software.
Memory layout validation failed.
Reading ECU flash memory failed. Trying to force ECU to recognize read operation is complete.
Finished forcing ECU to recognize that failed read operation is complete.
Reading ECU flash memory failed.
100% complete.
Restoring Windows sleep mode.
Disconnecting because no response was received for the Tester Present message.
Disconnected
