Pages: 1 [2]
Author Topic: Best AFR for Perfomance vs. Economy  (Read 16850 times)
s5fourdoor
Hero Member
*****

Karma: +33/-3
Offline Offline

Posts: 617


« Reply #15 on: October 04, 2011, 10:18:28 AM »

injectors and spark turns off on decel.

ok so this isn't dangerous then?  thanks for the info btw...  could we put a link on the wiki for this?
Logged
NOTORIOUS VR
Administrator
Hero Member
*****

Karma: +58/-7
Offline Offline

Posts: 1056


« Reply #16 on: October 04, 2011, 11:15:42 AM »

no it's no dangerous... it prevents unburnt fuel getting to the catalytic(s).  Every FI car does this (some very early fuel injection cars don't but that is still very rare).

Logged

SCHNELL ENGINEERING BLOG ·  STANDALONE ECUS · TUNING · DYNO · WIRING · PARTS · VEMS
Google Talk: NOTORIOUS.VR
n00bs start here: http://s4wiki.com/wiki/Tuning
Rick
Hero Member
*****

Karma: +63/-4
Offline Offline

Posts: 704


« Reply #17 on: October 04, 2011, 12:52:50 PM »

As above,

it's been a feature of pretty much any ECU built in the last 25 years. 

It's a cat saving and fuel saving device. 

Nyet, I have done some work with leaded race fuel, which is pretty much completely knock proof, but I haven't come to a definite conclusion yet.  I suspect though that best power will be around 12.5:1, and pretty flat from 11:1 to 13:1.  ECUplot is really helpful for stuff like this Smiley

Rick
Logged
Giannis
Full Member
***

Karma: +11/-1
Offline Offline

Posts: 176


« Reply #18 on: October 08, 2011, 04:40:15 AM »

I am running for some time now lambda 1.10 at low load part throttle conditions and i am decreasing it as the load goes higher than 80% to stock 1.00. I have a noticable fuel economy without any problems until now. Do you think that this it too lean? I have an 1.8t engine 180 ps.
Logged
Gonzo
Sr. Member
****

Karma: +21/-30
Offline Offline

Posts: 483


« Reply #19 on: October 08, 2011, 02:16:32 PM »

No you should be OK Smiley
Logged
jibberjive
Hero Member
*****

Karma: +23/-2
Offline Offline

Posts: 536


« Reply #20 on: October 24, 2011, 12:53:56 AM »

What is stock AFR for under load and partial load, for the 2.7t?
Logged
robin
Full Member
***

Karma: +20/-1
Offline Offline

Posts: 139


« Reply #21 on: October 24, 2011, 05:40:02 AM »

stock 2.7T is 14.7 nearly everywhere, unless you're deep into 4th/5th gear during a long pull.
Logged
Pages: 1 [2]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.03 seconds with 17 queries. (Pretty URLs adds 0.001s, 0q)