Hi,

I'm flashing right now my ECU first time with the Nefmoto SW. The flashing takes long time (now +30 minutes). The software says that the "operation is in progress" and "disconnected". There is only one active button "Cancel current operation", it doesn't do anything.

I'm afraid to close the program, since I don't know if the flashing is going on or not.

Is it working, or not? What I should do?

Yes, I managed to flash it. The software was in some error state, and didn't do anything. I didn't know what it will print in the screen that what is doing.

I closed it, and started again. After that I started the flashing again, and it worked, but not perfectly. It stopped after a 1% transfer, and I had to restart the ECU. After that the software connected again and succesfully flashed the rest. I did this two times, and it worked the same way in both times. But it worked!