Pages: [1]
Author Topic: Car Starts- Can't connect with Vag or Nefmoto  (Read 5243 times)
iNSTRUCT
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 20


« on: November 04, 2011, 08:25:47 PM »

Like the topic says- Is it possible if one of the connectors touches a nearby pin, specifically pin 21 or 62 it will cause this issue?



I don't think pin 1 & 2 have touched 3.  Thanks in advance.
Logged
iNSTRUCT
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 20


« Reply #1 on: November 04, 2011, 10:34:27 PM »

Since I was using alligator clips I think it's possible 21 or 62 touched 43- Is it possible I could have fried the communication controller?
Logged
iNSTRUCT
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 20


« Reply #2 on: November 05, 2011, 02:08:30 PM »

Looks like my blue vag cable has died - still curious about the answer.
Logged
iNSTRUCT
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 20


« Reply #3 on: November 09, 2011, 06:19:54 PM »

Luckily the ECU was not damaged. The blue light was still lit on the old vag cable but the communication controller was shot.
Logged
Rick
Hero Member
*****

Karma: +63/-4
Offline Offline

Posts: 704


« Reply #4 on: November 10, 2011, 12:01:05 PM »

You can't damage the K-line if you have 12V on it.
Logged
iNSTRUCT
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 20


« Reply #5 on: November 11, 2011, 11:58:42 AM »

You can't damage the K-line if you have 12V on it.

Thanks. I'm now almost certain I fried it because I only connected a ground to pin 4 and forgot pin 5 on the Vag cable.
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.025 seconds with 15 queries. (Pretty URLs adds 0s, 0q)