Hey, I'm sorry but I'm using a translator. I'm trying to read ecu but it crashes me, of course ecu on the table. Immo I removed but I do not know how to confirm without car.
Here are Flasher logs:

Validated FTDI device is in dumb mode.
Disconnected
Connecting...
Starting slow init connection.
Connecting to address 0x01.
Slow init succeeded.
Switching to KWP1281 session.
KWP1281 connect info: °6A906032DJ 1.8L R4/5VT     G   0002
Connecting to address 0x01.
Slow init succeeded.
Switching to KWP2000 session.
Connected
Disabling Windows sleep mode.
Reading ECU flash memory.
ECU reports programming session preconditions have been met.
Negotiating communication timings.
Successfully changed to new communication timings.
Requesting security access.
ECU reports that security access request was rejected.
Starting diagnostic session.
Disconnecting because no response was received for the Tester Present message.
Disconnected
Reading ECU flash memory failed.
100% complete.
Restoring Windows sleep mode.

Please HELP.

Okay, so could someone remove the immo from the file that is in the attachment?