this is my log file the ECU is on a test bench can anyone point me in the right direction?

09/Feb/2018 09:12:40.766: LOG: Opened FTDI device.
09/Feb/2018 09:12:40.879: LOG: FTDI device info - Description: FT232R USB UART Serial Number: AH065EBS Device Type: FT_DEVICE_232R ID: 0x4036001 Device Flags: 0x0
09/Feb/2018 09:12:40.886: LOG: FTDI ChipID DLL is loaded, checking chip ID...
09/Feb/2018 09:12:40.890: LOG: FTDI device chip ID: 0x7AA6755B
09/Feb/2018 09:12:40.898: USER: Validated FTDI device is in dumb mode.
09/Feb/2018 09:12:40.961: LOG: Starting send receive thread.
09/Feb/2018 09:12:40.969: LOG: Send receive thread now started.
09/Feb/2018 09:12:40.974: USER: Disconnected
09/Feb/2018 09:12:40.985: LOG: Setting communication timings to defaults.
09/Feb/2018 09:12:40.990: USER: Connecting...
09/Feb/2018 09:12:40.997: LOG: Setting communication timings to defaults.
09/Feb/2018 09:12:41.004: USER: Starting slow init connection.
09/Feb/2018 09:12:43.610: USER: Connecting to address 0x01.
09/Feb/2018 09:12:46.413: LOG: Failed to read sync byte, guessing baud rate is actually 9600.
09/Feb/2018 09:12:46.455: LOG: Not enough key bytes, read: 0
09/Feb/2018 09:12:46.460: USER: Slow init failed.
09/Feb/2018 09:12:46.467: USER: Disconnected
09/Feb/2018 09:12:46.476: LOG: Setting communication timings to defaults.
09/Feb/2018 09:12:46.487: LOG: Closing FTDI device.
09/Feb/2018 09:12:46.543: LOG: Send receive thread now terminated.

You sure k line is hooked up?