Pages: [1]
Author Topic: me3.8.3 load specified vs corrected  (Read 4505 times)
Adrianb
Newbie
*

Karma: +1/-0
Offline Offline

Posts: 17


« on: February 28, 2018, 11:00:20 AM »

Hello, can anyone give me a hint or explain me why I have corrected load much higher than specified / actual?

 its 1.8T AGU with saab red top injectors, vr6 maf housing and k04-022 turbo

thank you
Logged
KasperH
Hero Member
*****

Karma: +24/-8
Offline Offline

Posts: 630


« Reply #1 on: February 28, 2018, 12:37:52 PM »

I'm not strong with m3.8.3, so it might not be helpful.
but did you rescale for the larger MAF housing?
Logged
overspeed
Sr. Member
****

Karma: +21/-5
Offline Offline

Posts: 388



« Reply #2 on: February 28, 2018, 06:13:26 PM »

just after requested load map you have a IAT based factor for load...
Logged
Adrianb
Newbie
*

Karma: +1/-0
Offline Offline

Posts: 17


« Reply #3 on: March 01, 2018, 03:38:40 AM »

ah, yes. It was IAT correction. Thank you !  Wink
Logged
Cezary2528
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 3


« Reply #4 on: April 29, 2020, 12:53:07 PM »

Hi, I am new here and I hope this is the right place to ask my question.
I have a very similar problem with 1.8t AGU.
I have AGU with saab red top injectors, standard maf
The controller introduces very large load corrections. This is very apparent at low speed. Corrected load is twice as high as specified. Which sensor can cause such large corrections? The flow meter measures ok, the probe works, temperatures also look OK.
In ecu is one error 00544 - Maximum Boost Pressure Exceeded 35-10 - - - Intermittent
Sometimes boost is normal 1.2 bar and sometimes boost up to 2 bar
Thank you in advance for your answer.
Logged
overspeed
Sr. Member
****

Karma: +21/-5
Offline Offline

Posts: 388



« Reply #5 on: April 30, 2020, 07:31:48 AM »

look IAT factor as I said before...
Logged
Cezary2528
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 3


« Reply #6 on: May 01, 2020, 05:32:56 AM »

IAT is intake air temperature?
This map ?
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.016 seconds with 17 queries. (Pretty URLs adds 0.001s, 0q)