Pages: [1]
Author Topic: 2.0Tfsi throttle body only opening 45-50% max whilst under load  (Read 4165 times)
Richym
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 15



I have an Audi S3 I’m stage 2+ tuning. When under load on dyno the car will only half open the throttle body. I’ve used same sw on other cars and had no issue. Also dose the same when using stock software.

Tried resetting adaptions. Has anyone seen this before?
Logged
Khendal
Full Member
***

Karma: +9/-8
Offline Offline

Posts: 226


« Reply #1 on: March 18, 2018, 03:16:33 PM »

I have an Audi S3 I’m stage 2+ tuning. When under load on dyno the car will only half open the throttle body. I’ve used same sw on other cars and had no issue. Also dose the same when using stock software.

Tried resetting adaptions. Has anyone seen this before?

Have you used software of another car? Or have you mounted engine and sensor of a different car?
Logged
gman86
Hero Member
*****

Karma: +45/-128
Offline Offline

Posts: 705


« Reply #2 on: March 18, 2018, 04:33:00 PM »

Logs? Files?
Logged
Richym
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 15


« Reply #3 on: March 20, 2018, 04:43:14 AM »

logs and files attached
Logged
gman86
Hero Member
*****

Karma: +45/-128
Offline Offline

Posts: 705


« Reply #4 on: March 20, 2018, 03:10:35 PM »

logs and files attached

Is this car DSG? Is the DSG mapped?
Logged
Khendal
Full Member
***

Karma: +9/-8
Offline Offline

Posts: 226


« Reply #5 on: March 20, 2018, 04:40:49 PM »

logs and files attached

Have you a def files? all i have don't match Sad
Logged
Richym
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 15


« Reply #6 on: March 20, 2018, 11:09:19 PM »

Is this car DSG? Is the DSG mapped?

It's DSG I've tested with and without DsG mapped same result
Logged
gman86
Hero Member
*****

Karma: +45/-128
Offline Offline

Posts: 705


« Reply #7 on: March 21, 2018, 12:00:15 AM »

It's DSG I've tested with and without DsG mapped same result

Log Accel pedal, torque specified by ASR and Torque reduction. MDNORM is stock, try setting to 340Nm.
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.017 seconds with 17 queries. (Pretty URLs adds 0s, 0q)