I was trying to read my narrowband o2 voltages using VCDS at idle however since this is a Seat it doesn't have labels to the voltages and what they refer to.

On block 031 I have two voltages, left-hand one stays at 0.850v at idle and the one next to it stays at 0.475 if I remember correctly. At full throttle the 0.850v goes lower to about 0.6-7 and in random points in the log it turns into something very close to 0 like 0.06 and similar to that. The one that is 0.475v stays like that throughout.

Any of you have a clue what the actual labels should be, and what the voltages should read? Have never tried to do this with a narrowband before.