Pages: [1]
Author Topic: Beginner :)  (Read 6725 times)
phub
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 5


« on: January 30, 2012, 02:50:20 AM »

Hey, Guys! Pretty new around here now Roll Eyes I've just bought an 1996 Audi A4 1.8 TQ. Absolutely original car, no chiptuning or tuning at all.
But i do have the big interest for electronic's, and i have also the Ross-Tech diagnostics program, with bought license for diagnostics for my car.
And read alot around here lately, got more interest for this.

I've just wondered, can i myself with NefMoto software actually chiptune my car myself.. So it increases HP from 150 to 190 f.ex?
 Grin
Logged
rob.mwpropane
Sr. Member
****

Karma: +32/-0
Offline Offline

Posts: 370


WWW
« Reply #1 on: February 01, 2012, 04:45:21 PM »

I doubt it, your car is most likely an earlier me5, or me3.
Logged

This has nothing to do with cars but you can see my glorifying job at,

www.MWPropane.com
phub
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 5


« Reply #2 on: February 02, 2012, 03:02:33 AM »

Aah, ok.. crap! :p Alot of extra work to chiptune that car then.. Found engine code AEB, and seemd to be me3 as you mentioned yes.
Logged
rob.mwpropane
Sr. Member
****

Karma: +32/-0
Offline Offline

Posts: 370


WWW
« Reply #3 on: February 02, 2012, 06:01:15 PM »

Aah, ok.. crap! :p Alot of extra work to chiptune that car then.. Found engine code AEB, and seemd to be me3 as you mentioned yes.

Not impossible. I don't have enough info about it, but it can be done. You can't read (as far as I've read anyway) the EEPROM via OBDII, however you can read with a programmer seen here;
 http://www.mcumall.com/comersus/store/comersus_dynamicIndex.asp

You may be able to write via OBDII, but you would have to do some more investigating to find out more about your ECU. There is some info about earlier Motronic cars on here, not a lot, but some.
Logged

This has nothing to do with cars but you can see my glorifying job at,

www.MWPropane.com
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.013 seconds with 18 queries. (Pretty URLs adds 0s, 0q)