Hey Guys...
Since a long time ago i drive around with my tuned map added launchcontrol with the script from this forum... It runs very fine for more than 100km a day...

I´ve two Maps: One with LaunchControl only and one with additional Pops&Bangs in Overrun.
So i´m flashing these two Maps if i want Pops&Bangs or not...

Now i´ve heared that it´s possible to switch overrun on and off... With A/C Switch or with Cruise Control Stalk...
A/C on: Pops&Bangs enabled
A/C off: Pops&Bangs disabled
or with Cruise Control switch on and off...

I want to try to make this with my Map so i don´t have to flash my Maps anymore...

Can someone give me a hint how this can works?!

I would be very happy if someone can help me...

Thanks a lot,
Flo

Search map for overrun in case of a/c switched on, in MED9.1 it´s available for sure. It makes sense because a/c compressor have a load too, this is why idle speed is higher too. So if you write high values to this map you have 2 different rpm where overrun is active or not when a/c is active or not...