Pages: [1]
Author Topic: Wideband integration help please  (Read 457 times)
1slicks4
Jr. Member
**

Karma: +0/-0
Offline Offline

Posts: 29



« on: October 29, 2018, 02:00:10 PM »

I have it reading at address 0X00381116 however it’s not reading the same as the gauge. Innovate lc2 using offset -9.6.   What am I missing.  If the gauge reads 7.4 the me7 sees 9.5 and it the gauge reads 22 then me7 sees 19.x. Any help is greatly appreciated.


Edit.   B5 s4 MBox

Its all because I own a B5 and LOVE IT!!!
Logged
AudiSportB5S4
Jr. Member
**

Karma: +0/-0
Offline Offline

Posts: 40


« Reply #1 on: June 04, 2019, 10:18:42 AM »

Not sure if you ever figured this out, but when I connected my Innovate LC1 controller to the unused rear O2 plug so I could log AFR, I had to go into the LM Programmer and change the settings for the second analog output that I was running up to that plug. Sounds like you may need to do the same. If you have one source that you know is reading you the correct numbers, when you open up LM Programmer just ensure that the other analog setting is matching that and they should line up. That at least solved it for me... GL!
Logged
1slicks4
Jr. Member
**

Karma: +0/-0
Offline Offline

Posts: 29



« Reply #2 on: June 08, 2019, 06:10:26 AM »

I’ll check on this.  It’s been months since I’ve driven the S4.  I trashed my clutch on my final revision and been to busy to mess with it. But I’m swapping my clutch next week and I’ll see where it sits.  Thanks for the info!


Its all because I own a B5 and LOVE IT!!!
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.013 seconds with 17 queries. (Pretty URLs adds 0s, 0q)