Pages: 1 [2]
Author Topic: VW Golf/Jetta/Bora - NA spec - 1.8T AWP 180hp - 06A906032RN  (Read 19100 times)
316LV
Full Member
***

Karma: +12/-2
Offline Offline

Posts: 150


« Reply #15 on: August 04, 2016, 08:12:54 PM »

So back to the question. Can I or can I not flash a stock 'rn' file over an 'lp' ecu? Simple question, only requires a 'yes' or a 'no'...

I don't have an LP file at hand, but the general rule is same bootrom will crossflash. Run ME7check on both and note the bootrom. Both are likely 5.12 which would make it possible.

If they are 5.12, you would be well served to note what Carsinc posted, namely the HS/HN option. -Adam posted his HN and a pretty good .kp/.xdf for it. Even if you start from scratch I would switch to a well defined SW for a less painful experience anyhow...
Logged

Go ahead and give me negative karma... I don't care if you like what I post princess.
TheCream
Jr. Member
**

Karma: +0/-0
Offline Offline

Posts: 41


« Reply #16 on: August 04, 2016, 08:16:26 PM »

well, I got my pigtails  to make a bench cable, which I did, and it works....although, i'm trying to read the ecu and it's been stuck at 'Reading ECU flash memory.' for the past 15 minutes. what am I doing wrong?
Logged
TheCream
Jr. Member
**

Karma: +0/-0
Offline Offline

Posts: 41


« Reply #17 on: August 04, 2016, 09:00:00 PM »

I cant even read the membanks on the gli ecu. the other ecu's sit at reading forever with no changes to the status bar or anything.
Logged
vwaudiguy
Hero Member
*****

Karma: +53/-37
Offline Offline

Posts: 2024



« Reply #18 on: August 05, 2016, 08:34:26 AM »

I cant even read the membanks on the gli ecu.

Where/what are the membanks? Never heard that terminology before.
Logged

"If you have a chinese turbo, that you are worried is going to blow up when you floor it, then LOL."
TheCream
Jr. Member
**

Karma: +0/-0
Offline Offline

Posts: 41


« Reply #19 on: August 05, 2016, 04:14:16 PM »

In the NEFMoto program where you go to Read Full ECU Flash, you have to choose the memory layout above it from some files. I have tried all of the layouts that came with the program and none of them work.

IE: C:\Program Files (x86)\Nefarious Motorsports Inc\NefMoto VW Audi ME7 ECU Flasher\Memory Layouts\ME7 29F800BB.MemoryLayout.xml ... none of the supplied layouts work to read the "RN" ECU of the 1.8t 6-speed GLI.
Logged
vw4life
Newbie
*

Karma: +0/-1
Offline Offline

Posts: 8


« Reply #20 on: May 13, 2017, 03:18:18 AM »

you try to copy their file then want them to warranty it and fix it? lol.
Lmao that's awesome.lol

Sent from my SM-G900V using Tapatalk
Logged
Pages: 1 [2]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.354 seconds with 18 queries. (Pretty URLs adds 0.001s, 0q)