I need some help figuring out what to change in the Hex code to delete sai and pass readiness. S4wiki tutorial does not apply to my me7.5.
I have my head wrapped around tunerpro and winols now. I need to know what addresses and values to change. I seen in one of the many posts I read that there is maf scaling required for this depending on how it's done.

Main thing is what addresses do I edit?
What do I need to change?   

Thanks, mbox definitions don't apply to me7.5. The sai delete tutorial is not the same addresses. Find mslub in my file definitions and come back and tell me it's the same. I can't find mslub. I found cdsls but that method doesn't pass readiness.

I understand this subject has been beaten to death on here but finding the specific data I need for my car is like searching for a needle in a haystack. I have literally spent the last 4 days non stop searching for this. I am not asking anybody to do it for me, I want/need to learn it, but really sick of reading post after post about someone's s4 me7.1.1 or whatever it may be that has nothing to do with my car. I found someone with the same car doing the same thing and it didn't give me anything useful, found a file with some definitions that are similar argdubs lp-pl.ak and then found the LQ.ols files same for the most part, but I can't find anything related to the addresses or values to change. not looking to be spoon fed just need direction and actual help.  I post this in the noob section because I'm a noob to this I'm no pro and don't claim to be so I'm asking for help, something I don't usually do. Been on here for years and this is only my 2nd post.

*Also, your file with SAI delete.

MSLUB, CDSLS, ESKONF changed.

Thank you, that was awesome of you to do that! I can compare it in winols and see what you did so I can do it later on other cars on my own..

Basically, you have to use a known file that is similar to the one you have and look for the same pattern of bytes around the map.

Failing that, disassemble.

That was very strange. Flashed the ecu with galleto in bootmode since nefmoto doesn't pass security checks on this ecu on the bench or the car, put it back in the car, and when I went to run TBA through set readiness in vcds it bricked the ecu. lost communication with the cable and it wouldn't start . I re-flashed the ecu with adams's map and I'm going to put it back in the car today to see if it starts.

Adam, where did you find mslub? Which map is it under in the definitions? I looked and didn't see it. I can run compare tool to find it as BlackT mentioned. I haven't got a chance to deconstruct your file yet.
Trying to get this car ready for emissions and a road trip sunday and I still need to replace the A/C system. Getting the car ready has been first priority. Adam, you saved me some time there, but now I have to finish the car before I can get back to learning this code. The wall (sai ecu delete instead of replace the pump challenge) I put myself in front of was my drive to learn this. I will just have to get this car done and move back onto my GTI for learning re-mapping.

Thank you.  I flashed that file and will try it.
The car also failed for o2 heating before all this. If that is b1s1 I will just replace the sensor if it's b1s2 I will want to write it out.
I think I can look at my GTI map and figure out what to do there. It's mafless, evap, sai, rear o2, n75 deleted. I also have unitronics 630BT map I can look at. 

the unitronic map will be useless to you don't even bother