LTFT works great thanks to gremlin. But the engine works badly, I forgot about EGR fueling corrections. ECU thinks that egr works and is open at low loads, so it decrease fuel trim (less o2 in the combustion chamber while egr opened) and LTFT is 25% and STFT ~20% Correction is not sufficient at decreasing load and i have unstable idle RPM with AFR ~16.

I don't know if EGR has typical map or one calculated parameter by MAP but in Funktionsrahmen i found parameters which should help.



Can you find this parameters? Thanks, because you really helped me a lot. If I change AGRRMAX and CWMDBAS to 0, this should be professional EGR off with all works great.

Finishally all ok. Ltft work, no errors, engine runs great. Thanks for help.

Are you too lazy to read the thread first?
All of the above just described the removal of the EGR in your 032G_4433 firmware.

If you read your post again, you will see two independent questions.
1. Mappack
2 Remove the EGR.
The second part was completely resolved in the posts in the thread above.
But you are so lazy that you ask it again.
In any case, after your comment, I have no desire to help you, although I have a complete solution for the mappack.

Similar mappacks available freely