hi all I have modified my stock file, and now I'm trying to write it, the problem I have is that when I opened my ECU to find the memory version, I found I have a Superchips chip, (it was mapped for stage 2 by the previous owner)

is there any way I can get around this?

thanks in advance.

replace with a stock chip and program in bootmode

Understood. Not knowing your level of knowledge in engine application.
But assuming zero, according your question.

My advice then would be not to make such a big change for first attempt.
Chance of killing engine is big in my opinion by that way.

Get an experienced tuner to help you. Lots of them here.
Or start with Stage1 Software Mods only for that engine with ME7.5.


Chip should be AM29F800B or AM29F800T. Don't know for sure. Guess is B.

the easiest way would be to acquire another ecu. clone the eeprom from the original ecu or just immo off. then flash the software version of choice to the new ecu and tune at will.

Very good suggestion. I was afraid the author is not capable of doing so but some experience with that stuff is there.


Good Luck with your project

thanks, chap, of course, I still have a huge amount to learn on this,
I have done some mods to the ECU file, my problem is, I have nobody to check to see if I have done them correctly so far.

regards luke.