Audi 4.2 (D3) converted to manual, what needs to be bypassed on ECU

Pages: [1]

« previous next »

Author

Topic: Audi 4.2 (D3) converted to manual, what needs to be bypassed on ECU (Read 2901 times)

ardillo lambo

Newbie

Karma: +0/-0
Offline

Offline

Posts: 4

	Audi 4.2 (D3) converted to manual, what needs to be bypassed on ECU « on: December 01, 2019, 03:40:13 PM »

Folks,

Get my hands on a 2005 4.2 that I'm using as a power plant for a custom mid engine application.
I can run the whole show (ignition and fuel delivery) with an after market ECU, but would like to use factory ECU (Motronic ME7.1.1) to keep some features that can't be controlled with the after market ECU such as drive by wire (DBW) among others, also want the car to pass emissions when is needed.

Since I'll use a manual transaxle, a ref-flash can remove all the data the ECU is expecting from the automatic transmission. Besides the transmission stuff, what other things can be removed??

Can the engine be started without an connected transmission? just for testing

Regards,


	Logged

fluke9

Full Member

Karma: +26/-1
Offline

Offline

Posts: 113

	Re: Audi 4.2 (D3) converted to manual, what needs to be bypassed on ECU « Reply #1 on: December 02, 2019, 07:37:25 AM »

Quote from: ardillo lambo on December 01, 2019, 03:40:13 PM

I can run the whole show (ignition and fuel delivery) with an after market ECU, but would like to use factory ECU (Motronic ME7.1.1) to keep some features that can't be controlled with the after market ECU such as drive by wire (DBW) among others, also want the car to pass emissions when is needed.

A VEMS with DBW controller is ~ 500€ , most standalones can drive DBW meanwhile.
Most offer customizeable CAN messages and more. But yes its a bit of work to wire "everything"(tm) in.

Do you have OBD CARB readyness testing?
Here its only done with a gas analyzer, and i always passed that with standalones with better results than factory if tuned correctly for that.


	Logged

prj

Hero Member

Karma: +1072/-483
Offline

Offline

Posts: 6039

	Re: Audi 4.2 (D3) converted to manual, what needs to be bypassed on ECU « Reply #2 on: December 02, 2019, 08:01:53 AM »

Link standalone has OBD II support, can drive DBW and 8 cylinders sequentially.

What you are doing makes absolutely no sense. Throw your standalone into the trash, it's probably 10+ years old, and get a decent one.


	Logged

PM's will not be answered, so don't even try.
Log your car properly - WinOLS database - Tools/patches

Pages: [1]

« previous next »

Jump to:

Navigation

Personal Tools

November 29, 2024, 05:12:11 AM

Welcome, Guest. Please login or register.
Did you miss your activation email?

Navigation

Personal Tools

Search