Hi there,

I am looking at making a DPF off solution for this file.

I believe I have located the DPF/FAP switches at BFB53 and BFB54.

DPF/FAP maps appear to be at BF1FC, BEF86 and BF472 but the values in those maps do not seem to make much sense.

The car has the DPF deleted as well as the EGR blocked off. I am trying to locate the correct maps to zero out the EGR, also I am trying to locate the check engine code switches for both lambda sensors, both pressure sensors, the three egt probes and the exhaust flap since they are all disconnected with this downpipe.

Any guidence would be greatly appreciated. Attached is the stock read from the car.

https://mega.nz/#!UUkjhKga!q5FxKrMxb4sgIGIh09rrZJ0_ahBj4uuUK2e5p-Y9OQg

Cheers,

Thank you for the guidance. Much appreciated!

At this point I am trying to locate the maps and use this as a learning opportunity for myself. But, if I am unable to figure it out I will definitely be looking for someone to code it for a fee, and will definitely keep you in mind.

Thanks again!

Boost control will be fine, it's EDC17 with electronic actuator.

Cross flashing software is much more difficult than just removing it.
You can try to search for software for Russia if it exists, but there can be other compatibility issues, because there are often some other changes on the engine besides just lack of EGR and DPF.

Everything works fine with dtc's off until you have a car that runs fans all the time
Or randomly cuts power because diff sensor is bad.