Validated FTDI device is in dumb mode.
Disconnected
Connecting...
Starting slow init connection.
Connecting to address 0x01.
Slow init succeeded.
Switching to KWP2000 session.
Connected
Reading all ECU info.
Starting diagnostic session.
Unable to properly start diagnostic session, attempting to continue with current undefined session.
Negotiating communication timings.
Successfully changed to new communication timings.
0% complete.
20% complete.
40% complete.
60% complete.
80% complete.
100% complete.
Read 5 ECU info entries:
0x92, System Supplier ECU Hardware Number: 0261208291
0x94, System Supplier ECU Software Number: 1037369320
0x91, Vehicle Manufacturer ECU Hardware Number: 0x0D, 8E0909018A  , 0xFF
0x9B, Calibration Date: 4B0906018DP , 0002, 0x030040A7, 0x00000000, 0x14BF, 1.8L R4/5VT    ,  G   
0x9C, Calibration Equiment Software Number: 0x00000000
Reading ECU flash memory.
ECU reports programming session preconditions have been met.
Negotiating communication timings.
Successfully changed to new communication timings.
Requesting security access.
Security access granted.
Starting diagnostic session.
Successfully started diagnostic session.
Negotiating communication timings.
Successfully changed to new communication timings.
Requesting security access.
Security access granted.
Validating flash memory starts at 0x00800000 and ends at 0x00900000.
Validation failed, ECU reports that security access is not granted.
Memory layout validation failed.
Starting to read data block.
Requesting upload from ECU for address range 0x00800000 to 0x00803FFF.
Request upload from ECU failed, ECU reports security access has not been granted.
Reading ECU flash memory failed. Trying to force ECU to recognize read operation is complete.
Finished forcing ECU to recognize that failed read operation is complete.
Reading ECU flash memory failed.