|
|
RENOxDECEPTION
Jr. Member
Karma: +3/-0
 Offline
Posts: 43
|
 |
« Reply #1 on: July 15, 2020, 01:15:58 AM »
|
|
|
KFZWMN 0x16DCC 12x16
Y- 16DB0
X- 16DC0
|
|
|
|
|
Logged
|
|
|
|
|
gremlin
|
|
« Reply #2 on: July 15, 2020, 01:59:57 PM »
|
|
|
KFZWMN 0x16DCC 12x16
Y- 16DB0
X- 16DC0
Not correct. Two maps KFZWMN -> $1230C and $123CC Axises -> $1350C (rpm), $13570 (rl %) |
|
|
|
|
Logged
|
|
|
|
RENOxDECEPTION
Jr. Member
Karma: +3/-0
Offline
Posts: 43
|
|
« Reply #3 on: July 15, 2020, 03:18:17 PM »
|
|
|
Thanks, do you know what map is at 0x16DCC then?
|
|
|
|
|
Logged
|
|
|
|
|
gremlin
|
|
« Reply #4 on: July 16, 2020, 06:16:05 AM »
|
|
|
Thanks, do you know what map is at 0x16DCC then?
KFZWMNKH |
|
|
|
|
Logged
|
|
|
|
RENOxDECEPTION
Jr. Member
Karma: +3/-0
Offline
Posts: 43
|
|
« Reply #5 on: July 16, 2020, 11:27:35 PM »
|
|
|
Thanks for the info  |
|
|
|
|
Logged
|
|
|
|
RENOxDECEPTION
Jr. Member
Karma: +3/-0
Offline
Posts: 43
|
|
« Reply #6 on: July 30, 2020, 03:12:09 AM »
|
|
|
I'm trying to dial my injectors in and am very close, -1.5% at idle, and -7.00% partial, but can anyone provide me with the location for "Codewort für Adaptionsfreigabe (NOLRA)"?
I've tried correlating it with a DAMOS file for a TT, but I'm not having any luck finding it.
|
|
|
|
|
Logged
|
|
|
|
|
BlackT
|
|
« Reply #7 on: July 30, 2020, 03:30:00 AM »
|
|
|
NOLRA at 0x18F3E CWSAWE 0x115C6 KFTVSA 0x19C96 KFNWEGM 0x19C78 |
|
|
|
« Last Edit: July 30, 2020, 03:34:12 AM by BlackT »
|
Logged
|
|
|
|
RENOxDECEPTION
Jr. Member
Karma: +3/-0
Offline
Posts: 43
|
|
« Reply #8 on: July 30, 2020, 03:34:04 AM »
|
|
|
That was so quick, thank you, I'll test it tomorrow.
Wait a minute, kftvsa worked, and so did cwsawe, am I mistaken?
I was messing with overrun fuel cut obviously, and my cluster will say an mpg for about 2.5 seconds after letting off the throttle, then go to ---
as for cwsawe, it wouldn't work without it.
You've thrown me for a huge loop on that edit my dude.
Guess I'll look into it more tomorrow.
|
|
|
|
« Last Edit: July 30, 2020, 03:42:53 AM by RENOxDECEPTION »
|
Logged
|
|
|
|
RENOxDECEPTION
Jr. Member
Karma: +3/-0
Offline
Posts: 43
|
|
« Reply #9 on: July 30, 2020, 09:52:59 PM »
|
|
|
NOLRA at 0x18F3E
CWSAWE 0x115C6
KFTVSA 0x19C96
KFNWEGM 0x19C78
 For CWSAWE, it should be a 00 factory, I believe. That address is default 18 (unless I'm mistaken and it's a binary edit like NOLRA is?) I'm also fairly confident KFTVSA is 0x19CA0, because it should be all 1.0's from factory (64 base 16 -> 100 * 0.010000 = 1.0)  And then that means that KFNWEGM and KFNWEGM variant are correct, pretty sure I tested those and fuel cut was always disabled when set above max rpm. NOLRA worked great though! Thank you  |
|
|
|
« Last Edit: July 30, 2020, 10:04:59 PM by RENOxDECEPTION »
|
Logged
|
|
|
|
|
BlackT
|
|
« Reply #10 on: July 31, 2020, 08:10:47 AM »
|
|
|
Sorry my bad, to much work these days.
Yes your offset are good, only CWSAWE is at 0x115BA(I acidently clicked adresse below in winols so i wrote a last post wrong)
|
|
|
|
|
Logged
|
|
|
|
RENOxDECEPTION
Jr. Member
Karma: +3/-0
Offline
Posts: 43
|
|
« Reply #11 on: August 05, 2020, 12:47:25 PM »
|
|
|
Sorry my bad, to much work these days.
Yes your offset are good, only CWSAWE is at 0x115BA(I acidently clicked adresse below in winols so i wrote a last post wrong)
No problem! Thank again for that! Well, I am preemptively looking for a few more maps for my ev14's, since I've had them before during winter and know how badly the car can buck in cold starts. http://nefariousmotorsports.com/forum/index.php?topic=320.msg53813#msg53813maps: FLRM - TMOT (engine temp dependent) FFRITMS - ITMS (engine start temp dependent) Neither of these are mentioned in any of my definitions. |
|
|
|
|
Logged
|
|
|
|
RENOxDECEPTION
Jr. Member
Karma: +3/-0
Offline
Posts: 43
|
|
« Reply #12 on: August 11, 2020, 01:09:02 PM »
|
|
|
Still no luck with finding the above, not too important now, although I would prefer to figure it out before it gets cold out. Anyway, I've been working on feed forward on my tune, did a ton of logs, found KFDRAPP (0x19BC3 in case someone needs it) and I now I cannot find the last map to make it work and hopefully fix my weird boost oscillation, LDDIMXN. If anyone could post a location for that map, it would be appreciated. |
|
|
|
|
Logged
|
|
|
|
RENOxDECEPTION
Jr. Member
Karma: +3/-0
Offline
Posts: 43
|
|
« Reply #13 on: August 11, 2020, 05:36:10 PM »
|
|
|
Found LDDIMXN, 0x1ED46
|
|
|
|
« Last Edit: August 12, 2020, 11:06:12 PM by RENOxDECEPTION »
|
Logged
|
|
|
|
RENOxDECEPTION
Jr. Member
Karma: +3/-0
Offline
Posts: 43
|
|
« Reply #14 on: October 27, 2020, 05:22:47 PM »
|
|
|
As predicted I'm having the same cold-start issues that I had with my previous car. Does anyone know how I can find these PID fueling maps without being a disassembly god? Maybe instead someone has the location for LRSGKTM, as I'm not sure that those two above maps are even in ME7.5. |
|
|
|
« Last Edit: October 27, 2020, 06:42:00 PM by RENOxDECEPTION »
|
Logged
|
|
|
|
|
