Pages: 1 [2]
Author Topic: BMW E60 Immo, anybody here?  (Read 10042 times)
path83
Jr. Member
**

Karma: +0/-0
Offline Offline

Posts: 29


« Reply #15 on: January 25, 2021, 04:52:06 AM »

BDM 100 Clone arrived today, sadly there is no adapter for connecting the EDC16 to the programmer.

I will try to get the Pinout from the adapter and connect it directly to the BDM.

Back soon Smiley
Logged
path83
Jr. Member
**

Karma: +0/-0
Offline Offline

Posts: 29


« Reply #16 on: January 25, 2021, 05:31:22 AM »

Can anyone tell me if the pinounts from BDM100 and EDC16 are correct as shown in the pictures?

And if the pictures are right:

Is 3.3V needed to read and flash the ecu?

Thank's in advance!
Logged
path83
Jr. Member
**

Karma: +0/-0
Offline Offline

Posts: 29


« Reply #17 on: February 01, 2021, 06:24:17 AM »

Got another eeprom reader and know its working ( i think so  Cheesy )

Attached the Binary from the 95640.

The ISN Code should be "D8 93", is that correct?

So writing these bytes ( 3 times ) from the old 525D ECU to the ECU Bin Attached, then making an EWS Abgleich the car should start?

Thank you!
Logged
path83
Jr. Member
**

Karma: +0/-0
Offline Offline

Posts: 29


« Reply #18 on: February 04, 2021, 12:13:16 PM »

Copied the ISN Number as written, but the car dosn´t start.

Made CAS - DDE Sync, it says startcode writen, engine start now possible, but the engine dosn´t fire up ( cranks, but no start )

Thanks to everyone wo is helping.
Logged
path83
Jr. Member
**

Karma: +0/-0
Offline Offline

Posts: 29


« Reply #19 on: February 04, 2021, 12:58:43 PM »

IT´S RUNING!

Copied the whole 30 Bytes was the solution.

THANKS EVERYBODY!!!!
Logged
Pages: 1 [2]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.012 seconds with 17 queries. (Pretty URLs adds 0s, 0q)