Pages: [1]
Author Topic: Help to log, "Error! Exit Code:4", VISUAL/ME7LOGGER  (Read 4031 times)
Parati
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 16


« on: August 18, 2021, 07:59:25 PM »

I tried to log my ME7.5 with a KKL CH340 cable, using the COM3 port, but get this message when I go to start the log on ME7logger Visual. The weird thing is, the values I want to log appear for an instant on the log page, but after this message pop up on my screen, the values stop reading, so I assume the PC is connected to the ECU successfully. Thanks in advance
Logged
mappie
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 1


« Reply #1 on: January 21, 2022, 10:55:05 PM »

1st. in VisualME7Logger: try to connect to car with Ignition OFF
  • .

wait a few..

Are you getting values? but 0000000's?Huh Good!

Now: Turn the Key to the ON (Ign. ON) position. wait a.. ..

Does it Freeze up with error Code 4? Better..!

now try to start logging the car when you removed the instrument cluster, if immobilizer is a deal...first start the car, remove cluster connector (where K-line is located) and now press start logging in visualme7logger.

Does it Log now?  Yes..? Great.. somehow the cluster is interrupting the K-line when trying to log. run a straight K-line from ecu pin to obd-device or fab some switch.
worked for me  Cool
Logged
BlackT
Hero Member
*****

Karma: +79/-40
Offline Offline

Posts: 1425



« Reply #2 on: January 22, 2022, 11:44:21 AM »

ME7VL and CH340, no
Logged
Blazius
Hero Member
*****

Karma: +89/-40
Offline Offline

Posts: 1282



« Reply #3 on: January 22, 2022, 01:32:01 PM »

CH340 does not matter, it works fine. Been using it for 4 years now.

You need to connnect with slow0x00 with engine OFF and ign ON, wont work any other way.
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.014 seconds with 17 queries. (Pretty URLs adds 0s, 0q)