Hello. I made changes to the maps in the 06a906032as driver, I uploaded the changes 5 times because I changed something all the time and everything was ok, the checksums were counted each time, after inserting the driver into the car and testing, I wanted to improve something else, but none of the programmers detects the ECU, mpps v13, mpos v18, kess, nefmoto flasher, galletto 1260, I also tried to do bootmode mpps but the same is the boot error every time I struggled for 8 hours, and the best vcds normally detects ecu and works. I just managed to do bootmode galletto1260 but after that still none detects the ecu. What's the problem?

I have ori eeprom and immo off because I was doing conversions with me3. 8.3 on me 7.5 and I did everything from scratch. I tried to re-load the EPROM also does not work because I thought that something could have changed in the emprom

Did you try do desolder the Chip an wrote with programmer?


Gesendet von iPhone mit Tapatalk