Pages: [1]
Author Topic: Immo Problem after batt dies??? HELPP  (Read 2949 times)
Vwvr61991
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 2


« on: March 18, 2022, 07:03:13 AM »

So wanted to purchase a 03' VW "New Beetle" and i go to meet the guy and the owner told me that it has been sitting for a year or so and that it drove just fine when he parked the car. Well i try starting it and of course its dead. So i get a freshly charged battery and swap it out. I Try starting it and it starts up just fine for 1 second and then dies. Sounds like an immo problem. there is the "car outline with key symbol" that's on the dash/cluster/speedo. Its solid though, not flashing. Not sure if that's all the info someone needs to help me out.
What i have done:

-New Battery.
-Taken both pos and neg  battery cables off battery and touched them together for 15+ seconds to reset ecu
-ran a diagnostic on VCDS i can post if needed? Only could communicate with the 01;Engine Module unfortunately. I cannot for the life of me remember if its a 2.0L or a 2.5L engine

 Wednesday,16,February,2022,03:51:53:47148
VCDS -- Windows Based VAG/VAS Emulator Running on Windows 10 x64
VCDS Version: 21.9.0.2 (x64)  HEX-V2 CB: 0.4608.4
Data version: 20210903 DS330.0
www.Ross-Tech.com




Chassis Type: 9C - VW New Beetle (1999 > 2010)
Scan: 01 02 03 08 15 17 19 25 29 35 37 39 46 54 56 65 75
 
-------------------------------------------------------------------------------
Address 01: Engine        Labels: 06A-906-032-AVH.lbl
   Part No: 06A 906 032 MG
   Component: 2.0l R4/2V      G   4633
   Coding: 00001
   Shop #: WSC 00066
   VCID: 6FBBD7D5FE868EB34EB-5184
   3VWBK21C33M416890     VWZ5Z0B7287195

11 Faults Found:
16804 - Catalyst System; Bank 1
            P0420 - 35-10 - Efficiency Below Threshold - Intermittent
19497 - Powertrain Databus
            P3041 - 35-10 - Implausible Engine Temp. Message from Inst. Panel - Intermittent
18613 - Performance Malfunction in Cooling System
            P2181 - 35-10 -  - Intermittent
17978 - Engine Start Blocked by Immobilizer
            P1570 - 35-10 -  - Intermittent
17977 - Cruise Control Switch (E45)
            P1569 - 35-10 - Implausible Signal - Intermittent
18058 - Powertrain Data Bus
            P1650 - 35-00 - Missing Message from Instrument Cluster
16497 - Intake Air Temp. Sensor (G42)
            P0113 - 35-00 - Signal too High
17071 - ECM Power Relay Control Circuit
            P0687 - 35-00 - Short to Plus
18057 - Powertrain Data Bus
            P1649 - 35-00 - Missing Message from ABS Controller
18044 - Powertrain Data Bus
            P1636 - 35-00 - Missing Message from Airbag Controller
16502 - Engine Coolant Temp. Sensor (G62)
            P0118 - 35-00 - Signal too High
Readiness: 0000 0000
Logged

adam-
Hero Member
*****

Karma: +124/-33
Offline Offline

Posts: 2179


« Reply #1 on: March 18, 2022, 08:13:42 AM »

18058 - Powertrain Data Bus
            P1650 - 35-00 - Missing Message from Instrument Cluster

CANBUS fault?
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.014 seconds with 17 queries. (Pretty URLs adds 0s, 0q)