Pages: [1]
Author Topic: Me7.1.1 repair st10 and flash chip replacment ?  (Read 2938 times)
Groopan
Jr. Member
**

Karma: +1/-2
Offline Offline

Posts: 31


« on: April 25, 2022, 05:13:09 PM »

Good day

I am unsure of where to post this

I have been given a me7.1.1 ECU  . The flash pin 24 was accidently sent 12v instead of ground why trying to place in bootmode . I have tried to communicate with vcds , eeprom,tools etc and was not able to get the ecu to respond .

My question is can I replace the st10 and flash and get this ECU to work again? I suspect the flash and st10 might have been damaged .

If this ECU can be repaired what do I need to read and flash the st10 ? The rest I can do with tools from this forum .
 
Any advice will be gratefully appreciated.

Logged
_nameless
Hero Member
*****

Karma: +374/-3457
Offline Offline

Posts: 3027



« Reply #1 on: April 25, 2022, 09:57:10 PM »

It's shot
Logged

UGT Performance | ME7.5 calibration editor, flasher & logger
Audi A4 B6 1.8T (early + late) · AWV / AWP / AWW
· VR6 in beta and 07K in progress
BMW N54, N55, F & G Series, ZF8 calibration editors
https://UGTuner.xyz/
https://github.com/ugtuner05-sys
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.243 seconds with 14 queries. (Pretty URLs adds 0s, 0q)