MED17.5 There is a large gap between the actual torque and the requested torque

Pages: [1]

« previous next »

Author

Topic: MED17.5 There is a large gap between the actual torque and the requested torque (Read 1397 times)

yangbohan

Newbie

Karma: +0/-2
Offline

Offline

Posts: 16

	MED17.5 There is a large gap between the actual torque and the requested torque « on: April 02, 2023, 09:16:12 PM »

Can you help me?I calculated and scaled KFMIRL and KFMIOP through the EXCEL table. There is a big gap between the calculated torque and the request, which caused the transmission oil pressure to not be controlled correctly. And there is a big shock phenomenon when upshifting，Replaced the K04 supercharger and upgraded the DQ500 four-wheel drive hardware,Where is my problem?


	Logged

h2esk

Newbie

Karma: +0/-0
Offline

Offline

Posts: 21

	Re: MED17.5 There is a large gap between the actual torque and the requested torque « Reply #1 on: April 03, 2023, 02:35:48 AM »

MDNORM?

Also lower your load, you are running out of MAP sensor range.


	Logged

yangbohan

Newbie

Karma: +0/-2
Offline

Offline

Posts: 16

	Re: MED17.5 There is a large gap between the actual torque and the requested torque « Reply #2 on: April 03, 2023, 05:16:17 PM »

Thanks! My request does exceed the maximum range, replace the pressure sensor with a higher range? The load can only be calculated to 2550=191%=400NM? In which module is this calculation in the function manual?


	Logged

Pages: [1]

« previous next »

Jump to:

Navigation

Personal Tools

November 26, 2024, 07:39:04 PM

Welcome, Guest. Please login or register.
Did you miss your activation email?

Navigation

Personal Tools

Search