Golf 4 1.8T AGU M3.8.3 06A906018R

Can you reset adaptive values in any way? Or is it something like a hard reset?
-I only know of the throttle basic setting.

Was playing around with 4bar FPR but my pump was not happy, need a new one.

Flashed back to stock for now, but the idle is going up and down for a few sec, when you go to a standstill
-Pretty sure it has done it before, but it just “fixed” itself

Was thinking about just disconnect the battery and connect + and - to remove discharge for a hardreset

Only when it have DTC? Or all the time?

Because I always clear DTC and do throttle basic settings (with a charger connected) after everytime I flash a file on these
-I still had the bad idle, but today it was gone

Then I donno why it does it? (It went away overnight)

But thanks! Good info (:

Tried to run a 4bar FPR on original file and then a file with FGATO to 0.75 and found my fuel pressure to low, so just flashed the original and changed FPR back to 3bar, then it started to go up and down in idle, thats why I was thinking it had to be adaptions. (Have been running Stage 1 for 2years without problems)

-My friend ran 4 Bar on stock file, so I had to test how it would behave on a 4Bar because to me it made no sense (Later found he had a FPR and Fuel pump was bad, so it only made 3,2-3,8bar fuel pressure)