Hi guys.
I have the problem that I don't have the right damos to open my transmission software. Since I want to run it on MaxxEcu and now have EXX mechatronics, unfortunately I cannot flash the data status to the mechatronics.
Now I have to set the correct teeth numbers in the new flash so that the translations fit again. Can someone please tell me the correct lines from the file? I upload the flash with the correct numbers in it.
The data should be in the following fields:
NsyZaehneGangP_ko 1-6
and
NsyZaehneGangS_ko 1-6
Here:
Axle gear ratios: 06B52C
Gear ratios: 06B51D
Primary gear ratios: 06B525
Please THANKS
![Wink](http://nefariousmotorsports.com/forum/Smileys/default/wink.gif)