Pages: [1]
Author Topic: How to set the KSTT map for LPG  (Read 960 times)
Kacpern
Jr. Member
**

Karma: +0/-6
Offline Offline

Posts: 39


« on: October 21, 2024, 05:43:10 AM »

Hello everyone, I'm looking for guides and advice on how to decorate the KSTT map.
Problem
At a temperature of 0 to 20 degrees, the starter turns for 2-3 seconds before it starts, then it starts and runs well (holds idle speed), has the power to drive.
The starting dose is significantly reduced compared to gasoline.
0-5 degrees 6.5ms
10-15 degrees 5ms
20 degrees 4 ms 

These are the best results. I tried changing them up and down by 0.1 ms many times, but it didn't help.
Logged
Kacpern
Jr. Member
**

Karma: +0/-6
Offline Offline

Posts: 39


« Reply #1 on: October 24, 2024, 08:22:03 AM »

Or in other words, how to measure whether there is too little or too much fuel when the lambda probe does not work because it is cold?

LOG
AND
MAP
0  -33°C
1   -18°C
2    -9°C
3    -1°C
4     15°C
5     21°C
6     32°C
7     57°C
8     69°C
9     73°C
10   98°C
11   132°C
« Last Edit: October 24, 2024, 10:46:17 AM by Kacpern » Logged
Kacpern
Jr. Member
**

Karma: +0/-6
Offline Offline

Posts: 39


« Reply #2 on: October 26, 2024, 12:27:56 PM »

Nobody knows anything?
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.012 seconds with 17 queries. (Pretty URLs adds 0.001s, 0q)