Pages: [1]
Author Topic: Bosch ME7.9.9 XDF OR DAMOS  (Read 453 times)
Antunesmano.rs
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 2


« on: November 05, 2024, 04:56:31 PM »

Hello everyone, I've been working on tuning my Chevrolet Vectra Flexpower N20XF 2.0 (I'm Brazilian). It has a Bosch ME7.9.9, and I paid someone to make a few adjustments to the file, but I wasn't quite satisfied with the results. So, I've been putting in the effort to learn more and more about this ECU. I ran some tests using a scanner, and the spark timing between 3500rpm and 6200rpm consistently stays between 29~27. Starting at 4000rpm, the MAP sensor drops from 910 to 940, and in the 2000 to 2600rpm range, the timing advance is reduced by 3 degrees. I need to adjust my calibration but am a beginner, and I'm looking for knowledge Cheesy

I see that you use TunerPro a lot; I’m trying to learn with WinOLS. The ECU was read using a KTAG; here are the files for comparison.
Logged
Antunesmano.rs
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 2


« Reply #1 on: November 05, 2024, 04:58:54 PM »

CORRECTION THE MAP DROPS FROM 910 TO 840
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.011 seconds with 16 queries. (Pretty URLs adds 0s, 0q)