Hello, today i read my ecu with nefmoto using ft232rl cable. I hooked up battery and laptop charger. Battery voltage was ~13,3v. i chose 29F800bb layout which i checked on the ecu chip. At first try i got a prompt saying memory layout validation failed, then i canceled and tried again it all went well file was read. After that i disconnected nefmoto and turned off the ignition. After that tha car cranks but doesn't start.

On top of that when i open the file in winols and use a2l file from damos intended for this car all 5618 maps can't be loaded.

It also might be important to add that to check memory layout i disconnected the ecu and didnt try starting car after that only tried when the read was finished.

VCDS shows error 18089 programming not finished

What do?