Hello guys, happy New Year to everyone.

Some time ago I tried to add launch control to my MED9 bin using NeuroSuite MED9 software.

I have to admit that it was unsuccessful and resulted in errors.

After some time, I noticed that some people here on NefMoto were trying to implement the ME7 soft lc using DNMAXH, NMAX, ITNMXH, and similar maps, also reading the s4wiki helped a bit.

Unfortunately, I had no success with this approach either.

The issue I am facing is that MED 9.5.10 uses NMAX as the generic rev limiter, and as a result I end up with a rolling rev limit at 4000 RPM.
From my understanding:

• NMAX is the general rev limiter

• NMAXGA is used when the vehicle is stationary

• NMAXOGGA defines the short-term overshoot

I am still trying to make this work, but it is difficult since I cannot identify where my mistake is.

I attached the ori bin that trying to achieve the soft lc.

 Hello Dande,

NMAXOGGA Maximum permissible engine speed (short increase). I have this on 0.00 and my launch rpm is at 3820.
CWMDBGFZ code word torque limitation vehicle,  mine is set to 0, but it can be set to 1. should i make it to 1?
KFMDBGRG Charge limitation based on gear (0–6) and RPM from 2,400 to 9,600, and all the map values are set to FF. i still cant understand this how to make it work probably should you change the axis?
TMMIBGR Threshold for torque limitation, value is at 143.3c.
VMIBGR speed threshold for enabling torque limitation, it is at 0.0 km/h.

I would love to read the FR, but I haven’t been able to find one anywhere.