Pages: [1]
Author Topic: MG1CS031 Remove MHEV Functionality / Coasting  (Read 1312 times)
xM1ke
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 18


« on: March 08, 2026, 07:46:46 AM »

Does somebody have a tested solution to remove the MHEV functionality (coasting/disengaging transmission, switching the engine on/off while driving between 55 km/h and 160 km/h) from this ECU (MG1CS031 / 2.0 TFSI MHEV DLVB engine code)?

Even after a full throttle pull with the engine in component protection mode, the engine will switch itself off instantly while in Drive. I would like to keep the normal start/stop button functionality as stock (i.e., when the car is fully stopped). I would only like to fully disable the MHEV functionality. All fileservices I contacted do not offer this service currently.

Software version: FL_8W09B7115R_0003
Logged
Leonhard
Full Member
***

Karma: +33/-2
Offline Offline

Posts: 128


« Reply #1 on: March 09, 2026, 12:19:39 AM »

You'll find these functionalities within the TCU calibration (DQ381)
Logged
IamwhoIam
Hero Member
*****

Karma: +106/-3012
Offline Offline

Posts: 1107


« Reply #2 on: March 09, 2026, 03:39:41 AM »

Except longitudinal engines never had DQ381 a trans attached to them LOL
Logged

I have no logs because I have a boost gauge (makes things easier)
Leonhard
Full Member
***

Karma: +33/-2
Offline Offline

Posts: 128


« Reply #3 on: March 09, 2026, 05:39:35 AM »

Yes, of course, longitudinal with DL382, same subject
Logged
xM1ke
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 18


« Reply #4 on: March 09, 2026, 10:31:15 AM »

The DL382 G2 TCU is not unlocked yet, some tuners have managed to turn the MHEV functionality off in the ECU.
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.045 seconds with 14 queries. (Pretty URLs adds 0s, 0q)