Hello everyone,

This is my second post in this forum so I apologize in advance if I my write is poor...

First, this is all the info I have of my car:
Europe Audi A4 1.8T AVJ 2002 150HP
hardware 0261207778
software 1037363466
bosch nº 8E0909518M

Now I bought a KKL FTDI FT232RL and a MPPS V16 cable.

With the KKL FTDI FT232RL with nefmoto I could read the ecu info and see the DTC codes, and when I selected the layout 29F800BB and it says: RequestUpload service is not supported. RequestUpload may have been disabled by aftermarket engine software.
I tried to disconect and connect again, try differents baud rates but it doesnt work.

Then I tried using MPPS V16 in virtual box. MPPS is able to identify the ECU correctly and displays the hardware/software numbers, but when attempting to read the flash I receive an error, if I remember correctly it was "Error reading flash".

As far as I know the ECU is stock, although the vehicle has had several previous owners, so I cannot be completely sure. Has anyone worked with this specific ECU/software combination before and got this error in nefmoto?

If anyone has any information or Im missing something, I'd be happy to answer any questions to provide more information. I will update screenshots of the errors tomorrow.

Thanks in advance to everyone who reads this <3

Hello VWvinny, thank you so much!! I will try to write it and update you soon