Hi
I noticed that changing (increased last 3 vaules in axis and columns)  KFMIOP/KFMIRL affects readings on 120block (calculation of engine torque - Nm).
On stock KFMIOP/KFMIRL i have 300NM, after i increased last 3 values in KFMIRL and increased last value in KFMIOP AXIS torque on 120block is lower and indicate only 270Nm, but in reality there is still 300Nm.

Which map correspond to KFMIOP/KFMIRL and needs to be changed ?

You wrote Nm is calculated from (miist_w - mdverl_w) * MDNORM and i increased KFMIOP , so now Nm should be higher than before ? but on 120block Nm are decreased.
miist_w =KFMIOP which was already increased , rest is stock, MDNORM stay 400Nm stock.
how to calculate increased value of MDNORM ?
mdverl_w - which map reffers to it ?

i search in fr , but it is quite complicated i think
yes i rescaled KFMIOP load axis only last higher value. rest is stock, and Nm are about 30Nm lower than before scaling KFMIOP.
KFMDS is stock now- have to be changed ?

i found Your topic Masterj with same problem, now i have to find KFMDS , because i haven't defined it in my mappack. probably it is near start 2782B  y 13064 x axis 1684A in my file