nano
Newbie
Karma: +1/-1
 Offline
Posts: 19
|
 |
« Reply #15 on: August 05, 2016, 07:20:48 AM »
|
|
|
If anyone have other good info about this algo please contanct me; I'm very interesting especially on CS2 algo. I can pay for it.
|
|
|
|
|
Logged
|
|
|
|
absetup
Newbie
Karma: +0/-0
Offline
Posts: 3
|
|
« Reply #16 on: October 21, 2016, 05:22:13 AM »
|
|
|
did someone found the cs2 algo?
|
|
|
|
|
Logged
|
|
|
|
absetup
Newbie
Karma: +0/-0
Offline
Posts: 3
|
|
« Reply #17 on: November 01, 2016, 02:13:20 PM »
|
|
|
Up
Envoyé de mon iPhone en utilisant Tapatalk
|
|
|
|
|
Logged
|
|
|
|
|
H2Deetoo
|
|
« Reply #18 on: November 02, 2016, 06:14:01 AM »
|
|
|
I have worked out the 32bit (CS2) checksum.
See attached document.
Best regards,
H2Deetoo
|
|
|
|
|
Logged
|
|
|
|
KMTech
Newbie
Karma: +1/-0
Offline
Posts: 4
|
|
« Reply #19 on: November 15, 2016, 05:48:42 AM »
|
|
|
Hello,
I've tried your solution for CS2 but it's not working. I've done all calculations on joined dump but didn't works. I've tried all combinations RefIN, RefOut, with end xor ffffffff, end xor 0, byte swap... thanks for your help
|
|
|
|
« Last Edit: November 15, 2016, 06:00:51 AM by KMTech »
|
Logged
|
|
|
|
|
H2Deetoo
|
|
« Reply #20 on: November 15, 2016, 08:16:46 AM »
|
|
|
Then you're making a mistake somewhere  If you can get CS1 working, then CS2 should be no problem. Just change the data area and the start value as suggested in the document. (Please note that you use correct endianess!) Rgs H2Deetoo |
|
|
|
|
Logged
|
|
|
|
gmgunderground
Newbie
Karma: +0/-0
Offline
Posts: 5
|
|
« Reply #21 on: November 27, 2016, 09:35:29 AM »
|
|
|
I'm a little bit late... Another info, CS1 is always present, but CS2 not  also look for 0xCCxx Inviato dal mio GT-I9505 utilizzando Tapatalk |
|
|
|
|
Logged
|
|
|
|
totalfree
Newbie
Karma: +1/-0
Offline
Posts: 2
|
|
« Reply #22 on: December 03, 2016, 06:06:36 AM »
|
|
|
|
|
|
|
|
Logged
|
|
|
|
leosmut
Newbie
Karma: +0/-0
Offline
Posts: 4
|
|
« Reply #23 on: December 05, 2016, 03:39:22 AM »
|
|
|
This was posted on another forum for the members there... And if you have the same username there then you didn't even give a thanks to the original poster. Or asked him... Not nice. |
|
|
|
|
Logged
|
|
|
|
|
f1torrents
|
|
« Reply #24 on: December 05, 2016, 07:44:57 AM »
|
|
|
Does it work or is it your standard .bin collector?
|
|
|
|
|
Logged
|
|
|
|
leosmut
Newbie
Karma: +0/-0
Offline
Posts: 4
|
|
« Reply #25 on: December 05, 2016, 08:40:03 AM »
|
|
|
Sure does it work and no, there is no bin collected. Why should anyone collect bins from edc17? You can not decode them without the correct flashfile from micro and they are useless.
|
|
|
|
|
Logged
|
|
|
|
|
f1torrents
|
|
« Reply #26 on: December 05, 2016, 09:14:55 AM »
|
|
|
There is a collector for bosch RB4 and RB8 cluster and those are useless without the encryption mask from the MCU in the cluster.
|
|
|
|
|
Logged
|
|
|
|
leosmut
Newbie
Karma: +0/-0
Offline
Posts: 4
|
|
« Reply #27 on: December 05, 2016, 09:32:56 AM »
|
|
|
There is a collector for bosch RB4 and RB8 cluster and those are useless without the encryption mask from the MCU in the cluster.
That proves there are stupid people around  |
|
|
|
|
Logged
|
|
|
|
|
macxxx
|
|
« Reply #28 on: December 05, 2016, 11:28:37 AM »
|
|
|
A little offtopic - what eeprom sits in a edc17 from vwpolo 1.4tdi? Need to retrieve pin from it. P/N is 045906013E edc17U01
|
|
|
|
|
Logged
|
|
|
|
leosmut
Newbie
Karma: +0/-0
Offline
Posts: 4
|
|
« Reply #29 on: December 05, 2016, 02:17:44 PM »
|
|
|
A little offtopic - what eeprom sits in a edc17 from vwpolo 1.4tdi? Need to retrieve pin from it. P/N is 045906013E edc17U01
Np. EDC17 has a Tricore controller with internal eeprom inside micro. Post your dump Flash+EEprom (in a new thread) and i or somebody else can calc this for your. |
|
|
|
|
Logged
|
|
|
|
|
