Pages: [1]
Author Topic: boot mode with ST10  (Read 4682 times)
lulu2003
Full Member
***

Karma: +11/-1
Offline Offline

Posts: 242



« on: August 11, 2013, 09:15:09 AM »

Hi,

are there bigger differences to read ME7 1 MB flash 29f800 with ST10 processor instead of normale old c167 in Boot mode?
I am not sure if I make an error by setting boot pin(s) or if my tool (MPPS) has problems with it? Currently cannot cross check with C167.

If yes, which tools instead of byte shooter , CMD etc. can do that?



Logged
ddillenger
Hero Member
*****

Karma: +641/-21
Offline Offline

Posts: 5640


« Reply #1 on: August 11, 2013, 10:57:24 AM »

That's the CAN-bus ME7.1.1 correct? If so, big differences getting into bootmode.
Logged

Please, ask all questions on the forums! Doing so will ensure the next person with the same issue gets the opportunity to learn from your experience!

Email/Google chat:
DDillenger84(at)gmail(dot)com

Email>PM
lulu2003
Full Member
***

Karma: +11/-1
Offline Offline

Posts: 242



« Reply #2 on: August 11, 2013, 02:00:35 PM »

I think I have a software problem:
meanwhile I can get it into boot mode, at least I managed to read 1MB external flash and there is an option to read the st10 flash.
but writing my 1MB file into the external flash does not work after erasing the flash...
Logged
vwaudiguy
Hero Member
*****

Karma: +53/-37
Offline Offline

Posts: 2024



« Reply #3 on: May 28, 2015, 10:41:51 PM »

Did you ever figure out your issue, lulu?
Logged

"If you have a chinese turbo, that you are worried is going to blow up when you floor it, then LOL."
Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.019 seconds with 16 queries. (Pretty URLs adds 0.006s, 0q)