Pages: 1 [2]
Author Topic: Timing pulled help  (Read 13451 times)
ddillenger
Hero Member
*****

Karma: +641/-21
Offline Offline

Posts: 5640


« Reply #15 on: October 28, 2013, 08:27:45 AM »

KFTARX 10x12 26c78factor 0.000031
KFTARXZK 26d68
KFTARX something or other 26E58

axis

temp .75x 19CDE
engine speed .25x 13434

But these have nothing to do with timing, they alter maximum specified load based on IAT's.
Logged

Please, ask all questions on the forums! Doing so will ensure the next person with the same issue gets the opportunity to learn from your experience!

Email/Google chat:
DDillenger84(at)gmail(dot)com

Email>PM
itemonsale
Full Member
***

Karma: +1/-1
Offline Offline

Posts: 59


« Reply #16 on: October 29, 2013, 11:14:19 AM »

Thank you everyone...

 I got the map dial in... are they all suppose to be around the value of 1 ?   .86 .92 1 ? what is the value I am entering? is that percentage of the power output? like .80 = 80%*TQ request?

Correct, it has nothing to do with the ignition directly, but since I am running a manual boost controller, if the specified tq over the target output it will have to reduce the power by either  retarding timing or reduce boost( in this case only reducing timing) , so I believe it is indirectly affecting it.
Logged
itemonsale
Full Member
***

Karma: +1/-1
Offline Offline

Posts: 59


« Reply #17 on: October 29, 2013, 06:20:50 PM »

Can someone tell me what is the name for  " Air Temp Timing Correction "  I found it on http://www.eurodyne.ca/forum/viewtopic.php?f=21&t=689.
Logged
BenR
Jr. Member
**

Karma: +2/-1
Offline Offline

Posts: 38


« Reply #18 on: November 05, 2013, 04:30:07 PM »

........
« Last Edit: November 10, 2013, 11:02:41 PM by BenR » Logged
Pages: 1 [2]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.027 seconds with 17 queries. (Pretty URLs adds 0s, 0q)