Hi All ,
Need some advice please,
Airflow is good , boost is where it should be - HP is right for the airflow however , the throttle plate wont go past 50 % . Pedal is at 100 %.
Could it be a mistake in PDKSD ? The ori PDKSD had all values greater than 0.95 (reference to VDKUG) and in the higher ratio and rpm areas of the map , more than 1.2
I changed PDKSD to the same as PDKSE as PDKSD structure follows the same as most of the 1.8 bins I have seen , could this have been the issue ? CWPLGU is set to 0 in the stock bin.
Gonna go physically check that the throttle goes to 100 % as well as check the adaption .
Any ideas ?
Are you trying to accommodate for a stronger actuator?
