Pages: 1 [2]
Author Topic: 022906032CN(golf mk4 R32), ME7.1.1G, read/write eeprom..  (Read 18957 times)
24vMk1
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 15


« Reply #15 on: July 18, 2014, 11:58:26 AM »

Didn't required to try without resistors... I succesfully read eeprom file in bootmode >>> (
"Another bootmode fail on 022906032CS ME7.1.1G": http://nefariousmotorsports.com/forum/index.php?topic=6383.msg59384#msg59384)
Logged
marcone
Jr. Member
**

Karma: +0/-0
Offline Offline

Posts: 41


« Reply #16 on: November 28, 2014, 09:24:12 AM »

I know it is an old thread but I have bemched my r32 ecu and it works well without the resistor but can any one tell me do you have to put the resistor back or can it run without it.


 Many Thanks MARC
Logged
hummel
Full Member
***

Karma: +1/-1
Offline Offline

Posts: 62


« Reply #17 on: July 16, 2018, 01:32:15 PM »

Bringing an old thread to life...

I have a 022906032CE, ME7.1.1.

Should i remove the resistor to get it into boot mode as well ? And can it be leaved of ?

I can't connect to the ECU i OBD mode, so I guess i will try boot mode,...
Logged
_nameless
Hero Member
*****

Karma: +342/-466
Offline Offline

Posts: 2802



« Reply #18 on: July 16, 2018, 06:19:40 PM »

Bringing it back to life would be adding relivent info. Use hot air and pull the Eeprom off dump it with a chip burner and write it back to to the Eeprom then stick it back on the ecu. Anything short of that you won't get any place besides a screwed up Eeprom and a paperweight if you do t have the right tools.
Logged

Giving your mom a tuneup
Pages: 1 [2]
  Print  
 
Jump to:  

Powered by SMF 1.1.21 | SMF © 2015, Simple Machines Page created in 0.015 seconds with 18 queries. (Pretty URLs adds 0s, 0q)